How To Examine and Change The Belt Change In A Whirlpool 27 Inch Electrical Or Gasoline Dryer

Open the door on the dryer and attempt to flip the drum both clockwise or counterclockwise. In the event you may flip the drum simply with out a lot resistance, most certainly you’ve gotten a damaged or derailed belt.
Disconnect the dryer from the wall outlet
Open the toe panel and look to see if the belt is damaged or simply derailed from the motor & loafer pulleys
If the belt is damaged you will want to interchange it and if it has derailed from the motor & loafer pulleys and the belt appears to be like in good condition, simply reinstall it
Methods to dismantle the dryer whirlpool dryer repair los angeles.

Open the controls panel
Unscrew the three high panel holding screws and take away the highest panel
Take away the toe panel
Disconnect the door change from the wire harness
Unscrew the holding screws from the entrance panel and take away the entrance panel
Take away the drum from the dryer
Now you could possibly examine the belt change and the change actuator
Methods to examine & exchange the belt change

Disconnect the wires from the belt change
Set your multimeter on the bottom scale to learn ohms
Make it possible for the loafer pulley’s arm will not be pushing on the belt change actuator
Take a studying between the two terminals on the change
The studying needs to be near zero ohms to ensure that the electrical energy to have the ability to move to the motor
If the studying is infinity, the belt change is dangerous and it have to be changed
Methods to exchange the change

Unscrew the two holding screws and take away the change with the actuator
Set up the actuator on the brand new change
Set the brand new change in place and screw within the holding screws
Methods to put the dryer again collectively

Set the drum in place ensuring that the drum is driving on high of the rear drum assist rollers
Place the belt across the drum. Make it possible for the ridges on the belt are dealing with the drum
Get on the ground and stick your palms beneath the drum. Seize the belt and make loop and place it across the loafer pulley
Push the loafer pulley to your left and place the belt on the motor pulley
Set up the entrance panel and safe it with the holding screws
Join the door change to the wire harness
Set up the highest panel and safe it with the holding screws
Shut the controls panel.

Leave a Reply

Your email address will not be published. Required fields are marked *